Honda

All tie rod end boots are torn or cracked; Cosmetic Wear As Shown In Photos - Tie Rods - Pair of front left and right steering tie rod assemblies. Fits 1988-2000 Honda TRX300 Fourtrax 2WD/4WD...

Steering Stem - Steering shaft assembly with lower splines and upper handlebar mounting plate. Fits 1988-2000 Honda TRX300 Fourtrax (2WD and 4WD models). Structurally sound with age-appropriate...

Seized internal components or cables; Cosmetic Wear As Shown In Photos - Carburetor & Cables - Keihin CV carburetor with attached throttle, choke, and brake cables. Fits 1988-2000 Honda TRX300...

Fuel Tank - Steel gas tank assembly with fuel cap and petcock. Fits 1988-1992 Honda TRX300 / TRX300FW FourTrax. Originally finished in Southern Blue, currently painted a faded red/orange. Includes...

Hardware Bolt Kit - Comprehensive set of original chassis and engine mounting hardware including engine mount plates/brackets, castle nuts, various length flange bolts, nuts, washers, springs, and...

Pedal, Gear Change - Original equipment steel foot shift lever with fixed rubber toe peg. Fits 1988-2000 Honda TRX300 FourTrax and TRX300FW 4x4 models. Splines are in good condition; shows...

Fan Control Unit - Oil cooler fan alarm/timer module with green 4-pin and 2-pin connectors. Fits 1988-1997 Honda TRX300FW FourTrax 300 4x4. Genuine Shindengen OEM component in good working condition...

Rear Brake Pedal Linkage Rod - Mechanical rod connecting the foot brake pedal to the rear brake system. Fits 1988-2000 Honda TRX300 Fourtrax 2WD utility models. Good structurally sound condition with...

Seized/stuck axle locknuts; Cosmetic Wear As Shown In Photos - Rear Differential Final Drive & Axle - Rear drive assembly including final drive gear case, rear axle shaft, brake drum housing, and...

Rust-through hole on the side of the muffler canister; Cosmetic Wear As Shown In Photos - Exhaust Muffler - Full factory exhaust assembly with integrated head pipe and spark arrester. Fits 1988-1991...

Rear Wheel Hubs - Pair of left and right rear wheel splined hubs with mounting studs. Fits 1988-2000 Honda TRX300 and TRX300FW FourTrax. Structurally sound with good splines, includes all wheel studs...

Rear Rack Center Bar Section - Steel ladder-frame support for the rear fender and luggage rack. Fits 1988-2000 Honda TRX300 and TRX300FW Fourtrax 300 models. Structurally sound with typical surface...

Rear Shock Absorber - Single rear mono shock with coil-over spring. Fits 1988-2000 Honda TRX300FW Fourtrax 4x4. Structurally sound with age-appropriate wear and surface rust on the spring. OEM...

Carrier, Front Luggage - Black tubular steel front cargo rack. Fits 1988-2000 Honda TRX300 FourTrax and TRX300FW 4x4 models. Structurally sound with age-appropriate vintage patina. OEM...

Switch Assembly, Starter - Starter solenoid relay with wiring harness and 2-pin white connector. Fits 1988-2000 Honda TRX300 and TRX300FW Fourtrax models. Structurally sound with age-appropriate...

Fuel Primer Pump - Manual fuel primer assembly with lever used for cold starting. Fits 1988-2000 Honda TRX300 and TRX300FW Fourtrax models. Structurally sound with age-appropriate wear to the...

Cracked, Cosmetic Wear As Shown In Photos - Used: See Video And Photos For Details Part is off a 1988 Honda GL1500 Goldwing

Cosmetic Wear As Shown In Photos - Used: See Video And Photos For Details Part is off a 1988 Honda GL1500 Goldwing

Corrosion, Cosmetic Wear As Shown In Photos - Used: See Video And Photos For Details Part is off a 1988 Honda GL1500 Goldwing

Cosmetic Wear As Shown In Photos - Used: See Video And Photos For Details Part is off a 1988 Honda GL1500 Goldwing